|
Just finished install of
Inlet and cold air intake. Inlet kit is not really needed if you ask me. Rubber coupler that was part of inlet kit had a cut in it right in the middle and thank god I've noticed it when i inspected before the install. Ended up using the rubber coupler that came with the cold air intake. Inlet pipe clamp and rubber gasket that goes on the inside of the inlet can be reused from the oem inlet pipe, if the kit wasnt purchased.
Not going to lie It was a bit of a b!tch remove oem parts to install new.
Wire to the MAF sensor is streched to the max btw, Dinan_Engineeringi would rethink the location of the slot closer to the engine a bit, Wires are under a bit of tension when plugged in had to pop the box with air filter, plug the sensor and then pull and push down to set it in place.
Other then that its not bad at all.
Does dinan plan on releasing strut braces for g05? Oem ones are super ugly.
|