[Bottom16]

Originally Posted by Dinan_Engineering

Have never fit the exhaust or mid to the M50i so couldn’t say definitively what may be needed but just from quick technical data the M50i piping is smaller so at minimum assuming the routing and clearances are the same the Dinan mid would require adapting/fabricating down a size to fit.

Thanks for the quick response and understood. With that said, what about M550i xDrive Mid/X-pipe? Would that pipe diameter be similar to the M50i’s?

I ask because I can say there is def demand from the G05 X5 M50i/xDrive 50i folks that are looking for some aftermarket exhaust stuff like this. 😊

Thanks again!