[per]

Have you tryed this solution for boot mode?

[QUOTE=Dustin@Vishnu;2134253]I have had a few people whose PROcede has gone into boot mode after trying to update their firmware. This can happen for a number of reasons, like a laptop dying in the middle of the firmware update. Getting everything back to normal is quite simple.

When you try to connect to the procede after a failed firmware update, the software will say "Procede in boot mode, please update firmware."

1. Go into comms> Firmware update, and update the firmware the same as you would otherwise.
2. At the end of the firmware update, the Procede will be stuck in the reset, and will not go online. So we need to manually reset the procede. To do this, shut down the Procede software, as well as the power to the procede (turn the car off). Leave the power off for at least 1 minute.
3. Turn the car back to the on postion, and restart the software.