[IND-Distribution]

Tools Required:

• Floor Jack and 17mm Socket
• 8mm socket
• Pry Tool
• OEM plastic rivets (4x) – 51 77 7 171 004
• Rivet Gun

Difficulty (1-5): 1

STEP 1: Loosen Lug Bolts

STEP 2: Jack up car and place jackstand

STEP 3: Remove Lug Bolts and wheel



STEP 4: Pull fender arch flare out and up from front bottom edge



STEP 5: Continue to pull out the front half of the fender arch



STEP 6: Remove 12x 8mm bolts holding the front fender liner in as well as 2x 8mm bolts attaching the brake duct to the liner. (Passenger side has 1 LESS 8mm bolt holding the liner in)

















STEP 7: Remove the front fender liner





STEP 8: Pry off the 2 plastic rivets holding on the lower bumper bracket. The top rivet may be more easily accessed from the back





STEP 9: Remove the bracket by pressing in the tabs clipped into the bumper cover





STEP 10: Remove 3x 8mm bolts holding on the upper bumper bracket and unclip the bracket from the fender





STEP 11: Separate the corner of the bumper cover and the inner brackets to expose the back of the reflector





STEP 12: Use a heat gun to soften the adhesive, be sure to keep it moving to avoid burning the paint



STEP 13: Starting at the bottom, use your thumbs to press in the reflector until it separates from the bumper cover. Use spreading tool to help separate the adhesive





STEP 14: Once removed, be sure to remove any adhesive from the inside of the bumper cover that didn't come off with the reflector



STEP 15: Peel the tape to expose the adhesive on the painted reflector and reinstall



STEP 16: Press all around the reflector from behind to secure the adhesive







STEP 17: Installation is the reverse of removal. When reinstalling the lower bracket, use 2 new plastic rivets and a rivet gun