Well..... that was a HUGE failure.... but, lesson learned.
Even welded.... one of them came loose.... the other came off. Incidentally, both were the outboard tips. The inboard tips stayed strong. It's because the outboard tips are just slightly lower, and they impact the bottom side of the exhaust trim, which I believe it what caused the install to fail.
.... and the fact that the ID of the tips was too large in the first place.
Lesson learned. No harm done. Very little money spent.
Nevertheless, I've taken my own measurements this time, and I feel much more confident buying a different set for considerably more money. They are already on the way.
I'll post up when "exhaust tips round 2" is completed.
|