Quote:
Originally Posted by Addbuyer
Mine measures 330mm. This allows approx 5mm either side of the factory join.
Can you not take it to an exhaust specialist and let them worry about the reinstatement H-Pipes?
Took Torquflow 3 hrs start to finish, they did 90% of the work with the system in place and dropped the exhaust down just enough for the weld around the top of the pipes
|
Thank you. 330mm... or 13 inches. I can work with that.
I don't have a lot of "specialty" places anywhere near me. And what few places there are.... are 2-3x more expensive, especially when you have an American accent.
I may end up going that route..... but this is a simple exhaust job. No "bends" requires. I have a difficult job paying anyone to do a job that I can do myself.