Parts Needed:
Crystal / Glass Volume control knob.
Can be purchased
HERE or
HERE
Tools needed:
Cordless drill
1/8in drill bit
Pick set
Microfiber towel
Step 1:
Place Microfiber on center console to catch shavings and prevent accidental scratches
Step 2:
Using 1/8in drill bit, drill a hole in the center of the volume knob. Try not to drill more than 1/4in deep.
Step 3:
Insert hook pick into the hole drilled. Position the handle of the tool so it is downwards and to the left (8 o'clock position). Slowly pull the handle towards the rear of the car. This will pop the tab on that side of the knob. Once you hear the tab pop off, stop pulling.
Step 4:
Remove the pick from the hole and reposition so that the handle is now facing up and to the right (2 o'clock position). Again pull the handle of the tool towards the rear of the car. This will pop the clip on that side of the knob.
Step 5:
Remove volume knob by pulling straight out. This should require no force.
Step 6:
Align new knob and push towards front of the car. The knob will push in easily. Remove protective film.
After:
Feel free to send me a message with any questions. I will be posting more DIY's as I continue to modify my G07.