|
Ohh and I pretty much used two tools. An small 8mm wrench with integrated ratchet on the box end and a 1/4 small socket wrench (90 Tooth to make it easier to ratchet), and used both a standard 8mm 1/4 socket along with a deep well 1/4 8mm. I only really used the deep well to start the screws back in, as it was tough to reach my fingers in to hold the screws and spin them in. I could more easily use the deep well without the socket wrench attached to get screw initially seated. I did that upper blind screw exclusively with the wrench as there is plenty of room for it, and pretty much used it on the lower screw towards the middle. The outside screw is soo hard to get to, the wrench just does not have enough room to move and hold it onto the screw head. So the 1/4 socket wrench with normal length 8mm socket was pretty much the answer for those.
|