Quote:
Originally Posted by maczrool
Quote:
Originally Posted by LexxM3
A few ideas, all a kind of user error, which is why a few of us insist on coders being detailed, attentive, and build up experience over time: - it is actually still working, but last set value was ASS on (light off); as you state, it is a memory, not a disable of ASS
- used Code rather than Code NCD
- Coded NCD but with an NCD file that was pre-ASS coded (example backup)
I am sure there are at least a dozen ways to slip up.
|
It’s not any of those things as far as I can tell. I tried diag mode with the engine off (pressed start button three times). Esys showed I was in diag in the lower right corner, but when I read the ECUs, I only got 10 as opposed to 36 with the engine running and none of the 10 were the one for ASS memory so I couldn’t proceed.
|
That doesn't sound right at all. You probably want to start at the top of your coding steps sequences as previously discussed. You might not have connected using the right ISTEP or failed to read SVT, or something like that. Impossible to tell remotely, but 10 ECUs in Diagnostic Mode is not right.