[Efthreeoh]

Originally Posted by billnchristy

Been a while, got some stuff done.
Top cowl on, began work on vent delete to minimize stuff getting in and starting the rotting process again.

Bought a bottle so I could mig.

Installed a windshield washer reservoir.

Wife finished a seat.

Thanks for making this thread, it very interesting to read. So based on the past few posts on the cowl replacement, it looks like the replacement sheet metal is glued into place vs. welding it, or is that just sealant?

I get the mod of closing up some of the cabin air intake vent, but why wouldn't you, or the replacement parts manufacturer place fine, hard screening under the vent area and add drains to the lower cowl panel.

Just curious.