Quote:
Originally Posted by randybobandy
Yup. Took the car out of the garage, left vehicle running, turned lights off, then held the stalk forward for 10 seconds. I never get the prompt saying anything happened. I have no clue what’s going on.
|
Perhaps you should try it again because you didn't follow one of the steps.
You wrote that you left the engine running...the instructions state to have the car in the
"drive-ready state" which I interpret as the
START button has been pressed (without foot on the brake pedal) so that control modules are powered but the engine is not running.
Functional requirements
The setting can only be performed when the vehicle is stationary. The drive-ready state must be switched on and the light must be turned off.
Adjusting the sensitivity
Push the turn signal lever to the front for approximately 10 seconds. The system responds more sensitively. A Check Control message is displayed.
Resetting the sensitivity
Push the turn signal lever to the front again for approx. 10 seconds or switch off the drive-ready state.
The sensitivity of the high-beam Assistant is reset to the factory settings.
FWIW...I have no desire to even mess around with this feature because it works so well on my f06. It seems to turn off the high beams way before it would blind oncoming traffic or slower moving traffic I approach from behind...as well as turns off when cars approach from a perpendicular angle (traffic approaching from side streets).