I was referring to the tab you marked as A. It is pointing down, if you bend it up (make it more horizontal) you can push it out of the slot. From there the tabs you have marked B can be be pushed out from behind. You should be able to see them . I trim tool would help but not required.
Quote:
Originally Posted by Milangel
Tried to do this on my own yesterday but got blocked at the very beginning. When removing the fender flare, the tabs that lock the flare to the liner are so stubborn to disengaged. Couldn't get any one of them out of position.
So when you are talking about the "bottom vertical tab", which one do you refer to in the following pic (marked up from the IND pic)? A or B? As I did not see A in your pic.
Also how did you get that done (bending tab A up from inside the fender liner and push it out from there)? Did you use any tools or fingers only?
For tab B it seems that I have to either push it from the front bumper ventilation hole (2nd pic), or pull it from the gap behind the flare (3rd pic)?
|