Quote:
Originally Posted by dombi
Update:
I used REW to make my frequency response measurements. Unfortunately RTA was set to Spectrum Mode.
Which is why the flat setting in my OP did not sound right. This was the reason why the flat curve did not work (in Spectrum Mode).
I should have been using RTA 1/48 octave.
After I noticed the mistake, I've redone all the measurements and the curves finally look a lot better.
A friend of mine also let me measure the frequency response of his B&W sound system in the X7. The response follows a 1dB/oct drop between 200 -> 20.000Hz.
The bass response was not very good... IMHO.
I've started following the same, trying to set my X5s speaker responses to about the 1dB/oct drop, and it sounds quite good.
|
What setup are you running?