And..... now on the first appearance accessories.
2x cerium grey fender M badges. Part # 51148094237
2x Autotechnik carbon mirror caps.
Fitment is superb. Install was about 45 minutes for the first (figuring out what I needed to do)..... and 10 minutes for the 2nd one.
Step 1 - pop the mirror loose by prying at the bottom, and then just let it dangle (no need to unplug, there was enough room). I would recommend using something WIDE, but that wont scratch. I ended up using a rubberized spatula, instead of a thin pry tool, because I didn't want to risk cracking the mirror. Worked perfectly.
Step 2 - remove 5 tiny torx screws from the inside of the mirror
Step 3 - gently push in the top 2 tabs that hold the mirroc cap on.
Step 4 - gently pry the mirror trim loose from the housing (only a few mm)
Step 5- gently pry the mirror cap off.
Step 6- install carbon mirror cap.
Step 7- press mirror trim back into housing, and into mirror cap tabs
Step 8- re-install 5 screws
Step 9- pop mirror back in.
|