|
I installed by BlackVue 2ch 750s last night. I used the passenger kick panel fuses F27 which was empty and F72 which was also empty. F72 is a micro-fuse, that's a switched source and F27 is a ATC fuse battery power. I run the Power Magic Pro for parking mode control. There is a ground screw right there as well, so it's a cake-walk to use the passenger kick for the install.
I ran down the A-pillar behind the airbag into the passenger kick panel. For the rear camera I ran in the headliner, then used the factory rubber grommets into the upper hatch. Took some fishing, but everything is in the factory run paths and obviously a very clean install. I did not have to cut or poke holes into anything. I just popped the rubber guide out of the hatch and car, then fed from the car out, then through the grommet and then into the hatch itself.
If you use one of the wire grabbers this like this, it's super easy to get it through things like the factory wiring paths and around the airbags.
|