View Single Post
      02-04-2020, 07:54 AM   #22
bodybybalco86
Enlisted Member
29
Rep
34
Posts

Drives: 2014 328i xdrive
Join Date: Oct 2014
Location: Massachusetts

iTrader: (0)

Thanks for the pics and write up. I found it very easy to pull apart the 2 halves after running a plastic pick down the middle seam. Also instead of pushing the blade leads from the top of the mirror in to the molex as shown by jmcmathortho, i just went thru the bottom. I also ordered the same grommet kit but ended up not using it because I ran my radar wires through the stem hole. Plenty of room to do so and doesn't affect range of motion of the mirror. It doesn't look as clean but I did not need to drill a hole.

Wish I took pictures but I couldn't pull apart the molex connector and I couldn't get the correct angles to push the blades from the top so I went from the bottom.

I hope this helps someone.
Appreciate 4
radmjk238.00
Noneya251.50