11-24-2022, 02:21 PM | #1 |
Second Lieutenant
112
Rep 225
Posts |
2019 G05
So my 2019 G05 just failed emissions. Anyone heard of this before because of coding. There is no tuner installed
|
11-24-2022, 02:48 PM | #3 |
Second Lieutenant
112
Rep 225
Posts |
I just bought from a dealership. Shop said that it was in not ready state
|
Appreciate
0
|
11-24-2022, 02:53 PM | #4 |
Second Lieutenant
112
Rep 225
Posts |
And It's CPO
|
Appreciate
0
|
11-24-2022, 04:43 PM | #5 |
Unapologetic Tool Hoarder
734
Rep 964
Posts |
How many miles have you driven since purchasing? Sounds like the system was reset or cleared (maybe by dealer) and you haven’t driven it enough since then.
|
Appreciate
0
|
11-24-2022, 04:47 PM | #6 |
Second Lieutenant
112
Rep 225
Posts |
Oh I've driven plenty of miles. My thoughts were that I coded truck to start in sport mode and when I did that when I use BimmerLink I would get errors in the motor electronics the errors said something about ambient temperatures not really sure exactly so I coded the truck back to starting in comfort and since then the info error codes are gone.
|
Appreciate
0
|
11-24-2022, 10:38 PM | #7 |
Major
2050
Rep 1,200
Posts |
Could have an ecu flash on it; can have BMW rewrite the whole ecu to resolve.
__________________
575RWHP F87 M2C - ECUTEK RACEROM with flex fuel tuning by Bend Calibration 1000+RWHP E46 M3, Lab22 Built Turbo S54, Bend Calibration Tuned - BMW Half Mile Record Holder |
Appreciate
0
|
11-24-2022, 11:09 PM | #8 |
Second Lieutenant
112
Rep 225
Posts |
Would think that BMW wouldn't CPO it with it being flashed
|
Appreciate
0
|
11-24-2022, 11:25 PM | #9 |
Second Lieutenant
112
Rep 225
Posts |
A check engine light came on a few weeks ago but I just cleared using BimmerLink. But I heard I may be stored and causing a problem
|
Appreciate
0
|
11-24-2022, 11:29 PM | #10 |
Second Lieutenant
112
Rep 225
Posts |
And definitely don't feel tuned. Power wise it feels stock
|
Appreciate
0
|
11-24-2022, 11:50 PM | #11 |
Second Lieutenant
112
Rep 225
Posts |
So I just read that every time you clear coded using BimmerLink it puts car into not ready state and needs to be driven too get into ready state again. I constantly check andclear any codes using BimmerLink and must have done this before I went for inspection not realizing what it was doing. Also since I change driving start mode back too comfort BimmerLink no longer has the errors in motor electronics ecu about ambient temperatures.
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|