[Keyser Soze]

Originally Posted by BigEvan1923

I just sent you a PM on this - thanks in advance!

I used SEM Self Etching primer #39673 ($30 Amazon) but also Rustoleum has one in dark green that would work (I used it on my 535 exhaust tips and it had no issues after years) and is available at Lowes Depot along with the engine paint - Duplicolor Low Gloss Black Engine Enamel #DE1634.

I might actually go back and put a coat of semi-gloss black engine paint on it since that would match better with the surround.

Also, doing this with cans is harder than just using an airbrush, where you can be very precise. I got a Paasche H-3MH for $60.

[BigEvan1923]

Originally Posted by Keyser Soze

I used SEM Self Etching primer #39673 ($30 Amazon) but also Rustoleum has one in dark green that would work (I used it on my 535 exhaust tips and it had no issues after years) and is available at Lowes Depot along with the engine paint - Duplicolor Low Gloss Black Engine Enamel #DE1634.

I might actually go back and put a coat of semi-gloss black engine paint on it since that would match better with the surround.

Also, doing this with cans is harder than just using an airbrush, where you can be very precise. I got a Paasche H-3MH for $60.

Thank you!!! I was thinking about using Semi Gloss DE1635 - along with the SEM 39673...might be the move

[BigEvan1923]

And the results. Not bad. Semi gloss looks good. Thank you Keyser Soze appreciate the help!

[Keyser Soze]

oh, that looks great and so do the flat black emblems!

[BigEvan1923]

Originally Posted by Keyser Soze

oh, that looks great and so do the flat black emblems!

couldn't have done it without you!

[itshere]

Originally Posted by xdriv3

Reviving this thread --

Just brought my car to the dealer, replacement is covered by warranty, but just curious what others have experienced in terms of the replacement part.

I have attached the replacement offered- shadow line trimmed on the outside and regular chrome on the inside. Compared to the old defective part -- the inside is painted dark gray.

Just curious what replacement you guys were offered?

My concern with the replacement is that the inside will not age well.

Hey, how did you remove them? Was it difficult? Mine are also showing peeling so want to powder coat them

[xdriv3]

Originally Posted by itshere

Hey, how did you remove them? Was it difficult? Mine are also showing peeling so want to powder coat them

So mine were replaced under warranty.

They no longer make the ones w/ the dark coating on the inside. Now it's chrome without the coat.

[itshere]

Originally Posted by xdriv3

So mine were replaced under warranty.

They no longer make the ones w/ the dark coating on the inside. Now it's chrome without the coat.

Hmm okay. I was going to powder coat my wheels so figured I’d do that as well but figuring out how to remove it and if it’s difficult or not

[5ive7even]

The silver on my 24 X5 was driving me nuts. I sprayed them this weekend using semi-gloss high-temp engine paint. Turned out great. Hopefully, they hold up well. Figure I may need to respray them in a few years, but we'll see.

The silver on the inside of the exhaust ports and the chrome model trim are a big miss by BMW for those of us that spec'ed the M-Sport packages.