|
|
|
2010 2011 BMW 5 Series Forum F10 F11 535 xd dynamic damping control failure |
|
Post Reply |
|
Thread Tools | Search this Thread |
05-03-2024, 01:39 PM | #1 |
Registered
0
Rep 1
Posts |
F11 535 xd dynamic damping control failure
Hi y'all,
I've got some problems with Dynamic Damping Control. Car is F11 535 xd Mechanic changed wheels. Shortly after at one time I've got "Cornering ability restricted" on the dashboard and "Dynamic Damping Control failure" on center screen. This looked like it happened randomly when changing from drive to reverse. Error persisted for half a day until I drove through a small bump and error disappeared. However this error would occur occasionally I would say at random times and would instantly disappear (you would hear infamous bmw chime and error would appear on the screen). Currently this error seems to be permanent and it does not disappear. This locks out different adaptive drive modes (only comfort is mode is available). Today I've checked active errors and found these: Central Gateway Module 2 errors 801C60: Flexray autolearn not ok 801C20: Central fault memory full Vertical Dynamics Management 1 error D754F0: Message (2.0.1, status bike node HR): not received Damper satellite, rear left 1 error F2EC06: FlexRay signal error - state road Integrated automatic heating / air conditioning system 1 error 8011BB: Stratification potentiometer on the right: short circuit to plus or interruption Damper satellite, front left 1 error F26C06: FlexRay signal error - state road Damper satellite, front right 1 error F2AC06: FlexRay signal error - state road It's interesting how three damper satellites are showing errors. Anyone have any ideas what could be happening there? |
Post Reply |
Bookmarks |
|
|