03-27-2024, 03:09 PM | #1 |
New Member
8
Rep 16
Posts |
ista+ programming with ENET cable
From searching it looks like the KL30 voltage monitoring when programming in ista+ is only possible with ICOM. So with ENET, I see “KL 30: -“ in the software.
If I set my PSU to say 12V, I get a message in ista+ "The battery voltage (terminal 30) is below the permissible threshold value of 12.55V", but don't get such message when it's at 13.8V. So I think my question is, am I good to go if ista+ doesn't pop up warning? Last edited by peteryu1131; 03-28-2024 at 07:32 AM.. Reason: fix image url |
Post Reply |
Bookmarks |
|
|