09-23-2022, 08:14 PM | #1 |
Second Lieutenant
75
Rep 287
Posts |
Anti Dazzle behavior on standard LED
I coded my 45e to enable anti dazzle and I have the standard adaptive LED lights. At night I see the light split for the tunneling effect but the high beams are not on when the light split for the tunnel. There are a couple of times where it looks like it turn on for a brief second. To me there is almost no benefit as it does not light the side of the road any more than just keeping the low beam on. Is this normal behavior for the adaptive LED?
|
09-23-2022, 08:36 PM | #2 |
General
13528
Rep 20,169
Posts |
Did you perform the full coding or the "quick and easy", incomplete way that was posted sometime ago? Either way, it sounds like it is not working correctly since anti-dazzle only works when the high beams are on. I have never heard of the tunneling when only in low beam.
To answer your question, it should work with the standard LEDs but people have posted that few coding companies won't do it to them because they say they had issues with it.
__________________
2021 BMW G20 M340i xDrive - Verde Ermes/Black - 03/2024.40
2019 BMW G05 X5 xDrive40i - Phytonic Blue/Cognac - 11/2023.50 |
Appreciate
0
|
09-24-2022, 04:15 AM | #3 |
Second Lieutenant
75
Rep 287
Posts |
I don’t know what is the quick and easy way. I VO coded without writing to FA then code the 5 modules. I then FDL the 3 region parameters in KAFAS based on the thread in the coding section with BimmerUtility.
|
Appreciate
0
|
09-24-2022, 07:57 AM | #4 |
General
13528
Rep 20,169
Posts |
Ok good. It is a method that should be ignored.
__________________
2021 BMW G20 M340i xDrive - Verde Ermes/Black - 03/2024.40
2019 BMW G05 X5 xDrive40i - Phytonic Blue/Cognac - 11/2023.50 |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|