Used the pdf from here to follow the remove / fitting instructions, was a bit daunting at first to not break any tabs , instructions didn’t mention the plastic rivot but luckily I had spares as I had a removable hitch installed so had rivets let over from that .
Only tools used were a trim remove kit and a pair of pliers to refit the plastic rivot .
Once the 2 screws and rivot are removed, slowly work your way from the wheel back with the trim kit ( I found the thin small head worked best ) using the winglet as a guide to where the tabs are , it’s a bit tight but they do give and slightly pull away as each tab is released.
Fit the winglet in reverse making sure the tabs engage in the bumper and reuse the 2 original screws.
As for the rivot I use the pliers against a trim tool to install it , you will find plenty of vids on YouTube.
All in took about 30 mins
Just the fronts to do tomorrow, and the rear roof threw spoiler to be delivered
